Custom Saw Blade

Material introduction YAMAOO section material, in the quality management of materials, with high standards of strict checks. The Germany Grasche, Japan's high-quality steel billet. Tungsten carbide partner : Ceratizit (Luxemburg), Sandvik (Sweden), Sumitomo (Japan) The use of Swiss imported heat treatment furnace in Taiwan processing, to ensure quality stability.

Processing Advantages YAMAOO imports Switzerland Bystronic laser machine, high precision cutting and processing. Germany Kahny brazing equipment Germany Vollmer grinding equipment. With excellent hardware combination for over forty years of software & experiences, YAMAOO will be your trusted partner.

User Case  SIZE : 136 x 105 x 5mm Due to 5mm a cut to remove head and tail and defective reimbursement, yield almost remain less than 40%, which means leaving 400kgs to finished product 1000kgs aluminum.  

Packaging and storage of proper management The original factory box has an important protection against the saw blade. Boxes are stored in a box, and no boxes or overlapping saw blades will damage the serrations. Proper management of storage and records will be the starting point for effectiveness.

Saw Installation Ensure the sawblade turns in the same direction as the spindle does. Lf not, accidents are likely to occur. Choose the flange whose inner diameter is the same as that of the sawblade but the outer diameter is a little larger than 1/3 (for multi-rip sawblade is 1/2) of the sawblade. Ensure the flange is clean, not over worn, bent and distorted shape. Check the tolerance between the sawblade and the spindle. Install the flange and fasten the screw. Be sure no people stand in front of the machine when starting the machine. Do not feed, just to check whether there is any vibration, radial or axial run out. Sawblade reprocessing such as bore trimming or reboring, should be finished by the factory. Poor reprocessing would lead to poor quality and may cause injuries. While installation, the sawblade should be 5-6 teeth higher than the board surface. YAMAOO TECHNICAL DATA Cutting material applicable cycle speed table Limit table of rotation number